How To Draw A Star Wars Fighter Pilot Helmet

Kids DIY Star Wars Helmet Tutorial

Sam loves trying new DIY crafts and activities with her children.

diy-star-wars-x-wing-fighter-pilot-helmet-tutorial

DIY Star Wars Helmet

Practice your kids love Star Wars? If so, this fantastic DIY Star Wars Helmet makes for an enjoyable arts and crafts project that looks super impressive too. I've adapted this from some of the corking tutorials found elsewhere on the web. This projection uses half of a florist'due south hollow display ball, which can exist purchased over at Amazon.

Effort it! May the force be with you lot!

Materials Needed

i ten half hollow Styrofoam / polystyrene florist ball (8 inch for young kids / ten-12 inch for older children)
two x paper plates
one 10 sheet acetate (ideally yellowish but articulate is groovy likewise)
Sparse white cardstock
Gum suitable for styrofoam / polystyrene (solid stick or cool gum gun)
Double sided tape
Paint or felt pens (yellow, blood-red and black)

Buy Florist Hollow Foam One-half Assurance

How to Brand a Star Wars Helmet Instructions

Step 1

Decorate the inside of both paper plates.

It's ok to be a fiddling creative here, simply these will be your helmet'southward side panels. If your kids find the blueprint too tricky to replicate, information technology'southward a good idea to become an artistic adult to mark out the black areas and let them handle the ruddy and yellow parts!

Step Ii

Cut out the long strip that volition make the 'Mohawk.' It will need to exist about 2.5 inches broad and reach from the front edge of the helmet to the back border.
Use a fine black pen to draw the stripes. The 2 outer yellowish lines should be slightly thinner than the outer cherry stripes, and the cardinal red stripe slighter wider again.
Pigment the stripes.

Step Three

Add the red circular motifs to the helmet. I've found that paint works all-time on styrofoam.
This is perhaps the trickiest part of the project, and it may require the steady hand of a grown-up to help trace the design out commencement.

Coil to Go on

Footstep Four

Create the visor. This needs to come to the child'southward nose, and so information technology's best to play around with templates made from newspapers till you lot're happy with a design. It should be about iii to 4 inches deep (top to bottom).
Add double-sided tape to outer front end edges.
Adhere to the helmet using sticky tape on the outer tiptop edges merely.

Step Five

Create the back panel from the white carte du jour. Information technology will demand to be roughly the aforementioned length every bit the plates.
Stick this to the back of the helmet. Styrofoam is not an easy surface to adhere to, and y'all may need to utilize a gum gun. I found using a solid glue stick worked well and just kept applying pressure level until information technology had taken.
Add together strips of double-sided record to the outer edge.

Step Six

Pop the plates the 'wrong' way and stick to the double-sided tape previously applied on the dorsum panel and forepart visor. The red sections should face towards the front and align.
Information technology helps to add some gum to the top role of the plate and stick this to the helmet, and so it is secure and flush.

Step 7

Attach the Mohawk strip to the helmet using double-sided record.
Information technology should overlap the visor.

Note: This version contains the yellow striped front end, which is optional and tin can exist incorporated into the initial blueprint or added as a split card console, which I did.